macrium reflect how to clone to specific partition

In addition, you could try the best free disk partition cloning software - AOMEI Backupper Standard to clone hard drive to another one and boot from it successfully. For more info, learn from cloned hard drive won't boot. If it's not, there is a possibility that the system reserved partition is on the wrong drive, you need to move system served partition to SSD. If your computer boot as normal, you can plug the old drive into the computer again. The new SSD is a primary partition and marked as active.Īfter that, you can take out the old SSD and let your computer boot from the new SSD.What should I do? ”įor this issue, you need to be sure the following things: I just want to keep the old drive and rename it with a different drive letter. The cloning process goes smoothly but my computer won’t boot properly after I change the drive letter of old drive and boot from new SSD. I try to clone it to a new OCZ Certex3 120GB SSD drive with Macrium Reflect free version. “I have an old Kingston 64GB SSD drive that contains my OS and programs. Need help: how can I clone my hard drive for free? Step by step guide: clone disk partition to SSD free in Windows 11/10/8/7.Best free disk partition cloning software - AOMEI Backupper Standard.Need help: how can I clone my hard drive for free?.You should boot from the new drive without any problems. IF you get an SDD that is a lot smaller, then before you do the cloning, you have to shrink the largest partition on the HDD (usually the OS partition), to the size such that it, and the other partitions, fit easily on the SSD. NOTE: To do this easily, the SDD has to be the same capacity as the HDD. That retains the physical address of the Recovery partition.īut, I would like to suggest an alternative along with answering your question about tools to be used.ġ) Download and install Macrium Reflect (MR) from here: Ģ) Connect the new drive to the PC using a USB-to-SSD drive adapterģ) Follow the instructions in this link: What often DOES work is shrinking the OS partition until ALL the partitions will fit on the SSD and then cloning the entire set of partitions. When folks migrate to SSDs from HDDs, they shrink partitions and that changes physical addresses. That is because it must be the same physical address on the new drive as it was on the original drive. It looks like it works, but then later, when you go to use it, it does NOT work. The Recovery partition to another drive does NOT work in most cases.

Macrium reflect how to clone to specific partition